Thread: injecting each day???

Originally Posted by perth_fit

Thanks mate ill have a look.

Hope i dont get bad pip from them areas.

www.spotinjections.com

Originally Posted by ryanwrath

Ok. I have been injecting at least once a day, a lot of times twice a day to get amounts I need. Not sure where you are at with every injection site, personally I won't hit my shoulders with anything besides b12 or hgh. I hate pip in shoulders. I had to start super low like .25cc. In biceps, tries, traps, and calves. Calves I wish I had started with just pushing pin in, pulling out, then maybe .10 cc. also, for me, having more sites avlble. Than I need, because sometimes no matter what, a pin will have lingering pip, and for safety,I give it a couple days after all pip has ended before considering that site again. Can't stress enough if you are lean, getting about 4000 ultra fine insulin pins, 5/8" long, 29g. This makes it extremely easy on you. I throw the vials using that day on a heat pad, or I. Microwave for 20secs., you can draw down no problem, or backload them. If the butyl stopper is hot, won't mess up needle bad. If the needle is constantly getting bad tip, then back load. This is total winner for me going into biceps, tries, traps, calves mostly, although I use it in quads, only place still using normal barrels is gluteus, because they can hold more. One other thing to consider is doing say once every two weeks, 1cc test undec, once a week 1cc test C, or whatever amounts you need, it gets you to desired weekly mg. Amount, but with much less in your dailies, which helps in site recovery time, and makes it much more pleasurable over time, if ed pin could be called that,lol. Cheers best of luck bro!

Edit: just reread your initial post, testP. Is pretty brutal pip, at least for me. I like it, like using it, but can't imagine say testp 300or maybe even 200. Th e pip on 1cc would in my mind be equivalent of 3cc TNE into anywhere. Mast, not as much problem. Same trend A. When running several compounds I have put th e total amount of each in a 3cc barrel, then backlogged slin pins to correct CC amount for the spot its going. This really cuts the pip on the test P, because it's now cut with other compounds. Other thing is if possible, put it only in muscles used that day, gets it out faster, shortens pip. Makes site available sooner.

Thanks for the info.

When your injecting ed there is a lot more to think about.

Ill look in to the slin pins as im around 9%bf.

Originally Posted by kubes

I do this too. As long as your lean enough and the pin get through the fascia it's fine

Hey Kubes

Do you think it will be ok to run tren a and test p eod and do mast e once a week?

Or stick with mast p and do ed shots.