-
Pain
I been getting some bad shots lately in my shoulder, I'm shooting t400,eq,npp,using 23 gauge needle X 1inch, arm hardly can move,didn't hit no vein or artery so just wondering if anybody has a problem with really sore arms and can barely move it! Any suggestions or input
Sent from my iPhone using Tapatalk
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
----
-
I moved this into the Anabolic Steroid Discussion forum for more help.
If you are putting all that in your shoulder you are going to be very sore.
How often are you injecting and how many milligrams of each?
Are you spreading your shots around?
----
-
Originally Posted by
PAiN
I moved this into the Anabolic Steroid Discussion forum for more help.
If you are putting all that in your shoulder you are going to be very sore.
How often are you injecting and how many milligrams of each?
Are you spreading your shots around?
400 mgs of test then 250 mgs of eq per shot then I shoot 200 mgs npp in opposite shoulder but it hurts a lot,puts me down for a few days so I work through it even though it hurts
Sent from my iPhone using Tapatalk
-
Post Thanks / Like - 1 Thanks, 2 Likes, 0 Dislikes
----
-
Sometimes high milligram gear has a little pip when you shoot your other shoulder with the npp does it hurt as Bad? Also have you found this to happen in every injection site you have used with it or just your shoulder?
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
----
-
Originally Posted by
stephen220
Sometimes high milligram gear has a little pip when you shoot your other shoulder with the npp does it hurt as Bad? Also have you found this to happen in every injection site you have used with it or just your shoulder?
Yes in every injection site it hurts few days after ,very uncomfortable plus limits my workouts as far as the npp sometimes it hurts but not as bad as the t400
Sent from my iPhone using Tapatalk
----
-
I would say it's because of the high concentration of the test some sponsors even sell an additive oil to help with high milligram gear. Hopefully someone here can give some advice on how to maybe lessen the pip. When I first started I had a problem with a high dosed gear I just tried to shoot into the muscle I was about to train hoping that getting all the blood in that area would help get it to absorb faster.
----
-
T400 and NPP 200mg/ml is gonna hurt anywhere you pin it .
The shoulder has 3 heads and bicep tendon runs under that to attach itself .
The Lats , Traps and Tricep attach in there somewhere too .
Imagine 2 interstate highways connecting North and South . Have a big semi truck spill its load . What happens ?
You shouldn't be pinning more than 1ml of Test 200~250 or 1ml NPP 100mg unless your a heavyweight or superheavy weight .
If your experiencing downtime then gains are harder to come by .
Drop those doses and trade it for 50~100mg/day Proviron . You'll have more usable Test and better gains with less effert and pain .
Drop Mike
DWBO
Only Email contact:
**[email protected]
Will read all emails.
Will not reply going forward to avoid malicious intentions
Sessions ID
052898656ca565dbc88a16a9bfcb3e19f553da021a91c6c6a0 ea3ea9f27f387311
----
-
Originally Posted by
Dont wanna be old
T400 and NPP 200mg/ml is gonna hurt anywhere you pin it .
The shoulder has 3 heads and bicep tendon runs under that to attach itself .
The Lats , Traps and Tricep attach in there somewhere too .
Imagine 2 interstate highways connecting North and South . Have a big semi truck spill its load . What happens ?
You shouldn't be pinning more than 1ml of Test 200~250 or 1ml NPP 100mg unless your a heavyweight or superheavy weight .
If your experiencing downtime then gains are harder to come by .
Drop those doses and trade it for 50~100mg/day Proviron . You'll have more usable Test and better gains with less effert and pain .
Drop Mike
DWBO
Is t400 from torax to much to shoot 1ml=400 mgs
Sent from my iPhone using Tapatalk
----
-
Originally Posted by
jayjo96792
Is t400 from torax to much to shoot 1ml=400 mgs
Sent from my iPhone using Tapatalk
We always thought if it didn't hurt it wasn't 400mg .
Try 300mg/ml gear
Toraxx has exceptional gear and his carrier oil seemed to be Painfree . I would try in the Glutes first and if you have a good experience then you can try 1/2ml in shoulder before I did 1ml . I would use a 1ml 29G slinpin with 1/2 inch pin for shoulder . Make sure you have that 1/2 inch in deep .
Pull 1ml out of vial with 23G syringe . Set that down and pickup slinpin . Pull the plunger out with your teeth and don't set it down while holding the slin syringe . Pickup the 23G syringe and put the needle in the barrel of Slin syringe . Fill the slin syringe with 1ml oil slowly so you don't have a bubble. Still holding the slin syringe set the 23G syringe down . Take the plunger out of your mouth and ensert in the back of slin syringe. When you start putting plunger in syringe turn needle up in the air so bubble goes up to needle top . Will take a few seconds to press air bubble out .
I work near a counter so syringes can be set on the edge with needle not contacting any surface . Any needle that touches anything other than a sterile stopper on injection point is unusable.
This all sounds very difficult at first and is tricky . But after a few times you'll get better .
I lost .10 ml a few times before perfecting this method . I promise it will be so easy inserting pin that you'll never wanna meet another 25G barrel .
Regards
DWBO
Last edited by Dont wanna be old; 02-04-2017 at 02:31 AM.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
----
-
Originally Posted by
Dont wanna be old
Toraxx has exceptional gear and his carrier oil seemed to be Painfree . I would try in the Glutes first and if you have a good experience then you can try 1/2ml in shoulder before I did 1ml . I would use a 1ml 29G slinpin with 1/2 inch pin for shoulder . Make sure you have that 1/2 inch in deep .
Pull 1ml out of vial with 23G syringe . Set that down and pickup slinpin . Pull the plunger out with your teeth and don't set it down while holding the slin syringe . Pickup the 23G syringe and put the needle in the barrel of Slin syringe . Fill the slin syringe with 1ml oil slowly so you don't have a bubble. Still holding the slin syringe set the 23G syringe down . Take the plunger out of your mouth and ensert in the back of slin syringe. When you start putting plunger in syringe turn needle up in the air so bubble goes up to needle top . Will take a few seconds to press air bubble out .
I work near a counter so syringes can be set on the edge with needle not contacting any surface . Any needle that touches anything other than a sterile stopper on injection point is unusable.
This all sounds very difficult at first and is tricky . But after a few times you'll get better .
I lost .10 ml a few times before perfecting this method . I promise it will be so easy inserting pin that you'll never wanna meet another 25G barrel .
Regards
DWBO
Been using t400 for a long time and only now it's starting to hurt every time I pin in shoulder,I'm talking that my arm is swollen for 4 days,the skin is super tight . Then goes back to normal Just been having a bad experience this time around and making me think that I should stop the t400
Sent from my iPhone using Tapatalk
----
stephen220 liked this post
bobhead thanked for this post
Reply With Quote
Bookmarks