Thread: Pip with gso

Originally Posted by Jaylito

Did you maybe hit scar tissue? I had that happened one time and I had a softball on my ass. Buddy gave me antibiotics and it went away

That could be possible

Originally Posted by Montego

It's probably just the high concentration.

If not, I would guess a reaction to the carrier/ba/bb ratios used.

If it's going away though, it's probably not dirty. No amount of ice and ibuprofen stops an infection. Unless you froze it to death

Probably this. T400 is some strong stuff.

Sent from my SM-G900V using Tapatalk

I'm about positive with the 400mg per cc is just to damn much for me. I have done the regular test e mast e from same supplier and g2g

Originally Posted by Kevo

I'm about positive with the 400mg per cc is just to damn much for me. I have done the regular test e mast e from same supplier and g2g

If your good with the other products that have the same carrier oil then it’s the high mg that’s killing you for sure!! I never pin anything that’s over 300mg/ml for this exact reason. Not worth it to me but at least now ya know


Sent from my iPhone using Tapatalk

Originally Posted by kaneman

If your good with the other products that have the same carrier oil then it’s the high mg that’s killing you for sure!! I never pin anything that’s over 300mg/ml for this exact reason. Not worth it to me but at least now ya know


Sent from my iPhone using Tapatalk

Definitely learned that lesson lol

Originally Posted by Kevo

I'm about positive with the 400mg per cc is just to damn much for me. I have done the regular test e mast e from same supplier and g2g

Here's what I do to minimize this reaction to high mg injects. Draw your pin and place it in a heating pad. Leave it for a few minutes. I've got some very high mg mix that I mix with my test 100 so as to pin once. I then mix it in the pin by leaving about 1 ml of air And tilting the pin back and forth. You can still see the swirl of high mg in the test mix. Heating this up has been about a 60% reduction in pip for me.

Originally Posted by Electromass

Here's what I do to minimize this reaction to high mg injects. Draw your pin and place it in a heating pad. Leave it for a few minutes. I've got some very high mg mix that I mix with my test 100 so as to pin once. I then mix it in the pin by leaving about 1 ml of air And tilting the pin back and forth. You can still see the swirl of high mg in the test mix. Heating this up has been about a 60% reduction in pip for me.

Bro I seriously just done that. It works amazing

Originally Posted by Kevo

Bro I seriously just done that. It works amazing

There you go brother .....bon apetit'