-
Heating gear
So heating gear up will make the gear flow better in Syringe or heating gear in the syringe will a hand warmer do the trick maybe heating pad don't feel like heating whole vial every shot opinions
Sent from my SM-N950U using Tapatalk
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
born liked this post
----
-
I run the syringe under hot water. Flows nicely
Sent from my SM-N920T using Tapatalk
-
Post Thanks / Like - 1 Thanks, 4 Likes, 0 Dislikes
----
-
No one is posting anything... Small bowl of hot water while you get things ready. By the time you pull it it's good. Or if you can pin in the shower the hot water will feel nice and you can massage it right after to reduce that pip. Put a blowdryer on it for a minute. These are just some ideas, hope they help brother!
Sent from my SM-N920T using Tapatalk
-
Post Thanks / Like - 0 Thanks, 3 Likes, 0 Dislikes
----
-
Originally Posted by
MADDXXHATTER
No one is posting anything... Small bowl of hot water while you get things ready. By the time you pull it it's good. Or if you can pin in the shower the hot water will feel nice and you can massage it right after to reduce that pip. Put a blowdryer on it for a minute. These are just some ideas, hope they help brother!
Sent from my SM-N920T using Tapatalk
I put mine slin pin in a cup of hot water for a few minutes than pin. That's if it's colder in my house. Does make it push in a lot easier with ease.
-
Post Thanks / Like - 1 Thanks, 3 Likes, 0 Dislikes
----
-
Man i just run hot water over my syringe for a few mins. That shit gets hot fast
-
Post Thanks / Like - 2 Thanks, 4 Likes, 0 Dislikes
----
-
Thanks bros
Sent from my SM-N950U using Tapatalk
-
Post Thanks / Like - 1 Thanks, 3 Likes, 0 Dislikes
----
-
I've never heated my gear, but may try it now.
Thanks for posting.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
born liked this post
----
-
Attachment 20765
Lol you guys are still doing it the old fashioned way!?
They have reusable 110 volt heaters now...
-
Post Thanks / Like - 1 Thanks, 3 Likes, 0 Dislikes
----
-
Will look into that lol
Sent from my SM-N950U using Tapatalk
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
born liked this post
----
-
I like to microwave a half cup of water for 30-40 seconds and place vial in there while I get syringes out, area to inject sterilized.
By the time that's done oil is heated nicely
----
Bookmarks