How do you heat injectibles

**Jimring** · 03-27-2018, 02:02 AM

Originally Posted by Boxsquatter

All kidding aside. What is the need for heating up oil.. I have never felt the need and I have shot probably by this point in my life a few gallons of oil into my body. Well a little exaderated but you get the point. I just use 23g pin to draw it out I never ever had a problem it sucks it right up and I just recently started using 25g for inject. It is less of a pinch but it takes a few seconds to get in. But I just have patience and keep pressure on the plunger. The only time I ever use anything smaller is when I get my hands on water based suspension then a insulin pin is great. SO PLEASE CLARIFY THE HEATING UP PART FOR ME

I have some test cyp I used for a month and had to stop it hurt so bad. It felt like it was crystallizing wherever I shot it and regardless of needle size.

I dont want to waste it but I absolutely can't use it how I was. I couldn't lift or even sleep on the injection site for a week after the shot.

I don't remember why I used to heat it up a long time ago that was like 10 years ago. I guess I made it go in easy. I used to do 3 ml at a time regularly so I guess I hated it up so we could go in quicker I don't remember

**Jimring** · 03-27-2018, 02:03 AM

Obviously I'm getting old I can't remember why I did stuff before and not even creative to come up with all these different heating methods that are suggested to me in this thread

**docgreen77** · 03-27-2018, 03:10 AM

Originally Posted by Jimring

Obviously I'm getting old I can't remember why I did stuff before and not even creative to come up with all these different heating methods that are suggested to me in this thread

I hear ya brother. Getting old does suck. Remembering when throw a shit ton of weight around was nothing. Then it’s, where are the machines at?

Sent from my iPhone using Tapatalk

**Boxsquatter** · 03-27-2018, 05:45 PM

3ml is a lot of oil in one spot the ass and quads can handle that any other muscle that is too much. I would split it. Also I always massage the area after inject to disperse the oil... that’s what I do

**moprmac** · 03-27-2018, 05:57 PM

I set the vial right on my glass top stove set on high till warm.

**Couchlockd** · 03-27-2018, 09:46 PM

I let steam from a microwave cup of water heat barrel BEFORE I swap to injection tip.

don't want nasty ass city water or any water for that matter touching my fresh pin I'm about to burry into my quad

**swolesteelers** · 03-27-2018, 11:48 PM

I put vial on candle warmer for 20 minutes then inject smooth as butter great for crashed gear

Sent from my SM-N950U using Tapatalk

**samg1** · 03-28-2018, 03:58 AM

I run it under hot water for 2 minutes, withdraw and inject it. Works great pip isnt as bad, Does whonders for Test prop

**enrod** · 03-28-2018, 02:09 PM

Coffee pot warming plate - take the pot off make sure there’s no water in the coffee maker. Five min later, good to go.

Sent from my iPhone using Tapatalk