Thread: How do you heat injectibles

I know someone who back in the day would lay a loaded syringe across the top of a lampshade frame over a hot lightbulb for 2 or 3 minutes before he shot up too heat and thin the juice which worked great, but the new govt mandated lightbulbs don't get hot.

How do you heat your injectibles for those that do?

I put my vial either under my arm or I’ll sit down and put between my legs. Then I’ll wipe the top with a prep pad so it’s a clean surface. I’ve noticed it pushes easier when it’s warmer. For me it is


Sent from my iPhone using Tapatalk

Originally Posted by docgreen77

I put my vial either under my arm or I’ll sit down and put between my legs. Then I’ll wipe the top with a prep pad so it’s a clean surface. I’ve noticed it pushes easier when it’s warmer. For me it is


Sent from my iPhone using Tapatalk

I just hold the pin under hot water from the faucet for a few minutes.


Sent from my iPhone using Tapatalk

Originally Posted by roadie

I just hold the pin under hot water from the faucet for a few minutes.


Sent from my iPhone using Tapatalk

I never thought about it that way. Or putting it in some hot water on the stove. A buddy of mine, puts his on the dash of his truck as he’s driving down the road. Either on a hot day, the sun will warm it up. Or if it’s a cold day, the defroster is on.


Sent from my iPhone using Tapatalk

Originally Posted by roadie

I just hold the pin under hot water from the faucet for a few minutes.


Sent from my iPhone using Tapatalk

same here , just enough to thin it out

I’ll microwave a cup of water and let the vial sit halfway for a minute, works great


Sent from my iPhone using Tapatalk Pro

Be careful heating it up in the pin, too hot will make you miserable. Body temp is perfect. I put mine behind my ear like a pencil for a few mins, or armpit.

BPP