Test E 400 and carrier oil

**Enigma** · 01-21-2019, 06:11 PM

“Pharma grade GSO” doesn’t mean it’s sterile, unless of course it is in a sterile, multi-use vial. Test e at 300mg shouldn’t be painful. Why not use .5 of the 400mg and .5 of the 200mg? At least you will be drawing from (presumably) sterile vials.

People are so cavalier about this injecting steroids thing. Sure, most people won’t have issues with injecting non-sterile shit into their bodies. That is until you do.

I used to race superbikes. I spent $7,000 in one season on tires (and I was a Michelin sponsored rider). My theory was that crashing and causing thousands of dollars in damage to my bike AND possible injury just because I didn’t want to spend $250 on a rear tire was pretty fucking stupid.
Now apply this to gear and something you directly inject into your body.

**Carbo2** · 01-22-2019, 02:04 AM

I hear ya. It is sterile oil. I’m gonna try mixing different combos...just have never had to go through so much BS to get my gear on board and want to make sure I’m on the right track. I bought a lot of T400 and just trying to figure out how to use it with at least moderate tolerability. I’ve learned my lesson...I’m done with T400. Lol. Oh well...

**Carbo2** · 01-28-2019, 06:33 PM

Op here again. Ok, so i was ready to throw my gear away and start over with others because the PIP was still rediculous. As a last resort, I heated some water to sub-boiling and placed a vial in the water, just below the top cap. I attached a paper clip around the top and bent it accordingly so I could moved the vial in the water as it heated. Did this for around 5 minutes and then shook vial vigorously and then repeated the heating again. Took around ten minutes...let it cool to room temperature. I pinned a couple of days later with NO PIP at all. I did use a 1:1 ratio of Test E to carrier oil. (My next pin I’ll try straight gear)Super smooth pin. No pip, swelling, etc. Crazy. Don’t know if it might help someone else but it appears to have worked here.