-
Slin pin question
Can all gear flow through slin pins? If so what size you suggest? 25 or 27 gauge? I've never tried this and don't want to waste 100 pins lol
----
-
Not all gear will depends on what oil it’s made with
----
-
Originally Posted by
MEB
Not all gear will depends on what oil it’s made with
Mct oil, but seems a little thick still. Love the gear though
----
-
I use a 29 in a 1cc just may have to heat it up
----
-
You can pull the Slin pin back and get it stuck so it slowly drains into the pin. Just prop the bottle up or hold it up
Sent from my iPhone using Tapatalk
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
----
-
To load the pin I back load
Sent from my iPad using Tapatalk
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
----
-
MCT oil flows fine. I have even used GSO but you need to heat it.
I use 27 gauge 1cc pins from Exel. The pins are removable so you don’t need to back load them.
Sent from my iPhone using Tapatalk
-
Post Thanks / Like - 2 Thanks, 1 Likes, 0 Dislikes
MEB liked this post
----
-
I think I'll back load. Just afraid 27 won't be thick enough. From the videos I have seen, it's different with slin pins. Maybe I'll try to go to Walmart and test those first. Any luck with theirs? Ask for 27gauge by 1/2in or 27 1in? I've never bought them, sorry I just need some help
Last edited by animal23; 02-16-2019 at 01:18 AM.
----
-
Originally Posted by
animal23
I think I'll back load. Just afraid 27 won't be thick enough. From the videos I have seen, it's different with slin pins. Maybe I'll try to go to Walmart and test those first. Any luck with theirs? Ask for 27gauge by 1/2in or 27 1in? I've never bought them, sorry I just need some help
I use 27 g 1/2” or 5/8”. I have never seen them in one inch. I use these for delts and quads. Below is a link to where I get them. GPZ is great. I’ve been using them for 10+ years.
For glute shots I use 25 g, 1-inch.
Before injecting I hold the barrel under hot tap water for a few minutes so the oil flows much easier. Again I use both GSO and MCT without issue.
What gauge do you typically use.
1 CC / Insulin Syringe with Needle - GPZ Med Lab
Sent from my iPhone using Tapatalk
----
-
Originally Posted by
sa355355
I use 27 g 1/2” or 5/8”. I have never seen them in one inch. I use these for delts and quads. Below is a link to where I get them. GPZ is great. I’ve been using them for 10+ years.
For glute shots I use 25 g, 1-inch.
Before injecting I hold the barrel under hot tap water for a few minutes so the oil flows much easier. Again I use both GSO and MCT without issue.
What gauge do you typically use.
1 CC / Insulin Syringe with Needle - GPZ Med Lab
Sent from my iPhone using Tapatalk
25g by 1 in. Trying to change spots and less scar tissue
That's where I get my 25 gauges
----
Bookmarks