-
Smallest draw needle
I’ve always used 18 gauge needle to draw and 25 to inject. I’d like to go smaller on the draw needle to lessen the size of the hole it makes. Been getting leakage lately. What’s the smallest I can go and still be able to draw ? 20G? 22G? I’m drawing Test Cyp. Thanks
Sent from my iPhone using Tapatalk
----
-
I’ve noticed even 20g makes a hole and could put pieces of rubber in your gear. 22g is perfect for drawing and 25g for injecting
Sent from my iPhone using Tapatalk
-
Post Thanks / Like - 1 Thanks, 2 Likes, 0 Dislikes
----
-
Never had an issue with 20g. 18g does leave a hole!!
Sent from my SM-G950U using Tapatalk
----
-
I draw and inject with a 20. I always pin my ass just can’t hesitate. I hate pushing so hard to inject. It flows right in. People think I’m crazy but have been doing it for the last 75 or so shots. No issues at all. It is scary the first couple times.
Sent from my iPhone using Tapatalk
----
-
I draw and pin with same 25G. I don't switch for new pin.
Takes a little more time.
Viscosity will depend on oil and percentages.
My Test E 300 and Deca 300 are 1%BA and 7%BB in MCT oil. I warm up by placing vial in hot water(not fully submerged). Takes 40 or so seconds to draw 1ml.
With Tren Ace, which I pin everyday when on...
I draw and pin with 27G.
I brew my Tren A 100mg/mL 1%BA and 18%BB in MCT oil, so it's easy flow and thin.
Even 20G I have seen it cause chunks of the vial rubber to be torn and floating around in the vial. That is why I quit drawing with larger pin.
Last edited by Plate Smacker; 04-02-2019 at 05:16 PM.
"It's a lot of hard work, it's hard work that most people don't realize. I think the consistency of the hard work, is the hardest part." Dallas McCarver
----
-
20g is what I use I'll never use a 18g again it acts like a hole punch and leaves chunks of rubber floating in the gear
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
----
-
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
----
-
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
----
-
Originally Posted by
Adrenaline
I’ve noticed even 20g makes a hole and could put pieces of rubber in your gear. 22g is perfect for drawing and 25g for injecting
Sent from my iPhone using Tapatalk
Yea man 18g does that shit to
Sent from my SM-G965U using Tapatalk
----
-
I drew with a 25 two weeks ago. Fuckers still filling.
-
Post Thanks / Like - 0 Thanks, 2 Likes, 0 Dislikes
----
Bookmarks