Thread: Winstrol Depot Gauge Size

Can anyone tell me the smallest gauge i can get away with drawing/shooting this? I have been using long esters only and shooting once a week with trt base (2yrs). Im using 22g 3cc atm and don't feel like harpooning myself everyday with that.

Much thanks

You could most likely get away with 25g. I don’t think there would be struggle drawing it up but if so heat up the vial in warm water, draw, pin done.
You could probably go smaller I’m just used to 25 as it always worked for everything.

Much Thanks

Originally Posted by 9TMARE

You could most likely get away with 25g. I don’t think there would be struggle drawing it up but if so heat up the vial in warm water, draw, pin done.
You could probably go smaller I’m just used to 25 as it always worked for everything.

So i tried the 25g and it draws but not all the particulates come through and left with more solution than anything. Used 22g to draw then switched tips, that bitch clogged on the last .2ml aint happening. Been using 22g and it still clogs some at the end of injection, but can force it out. Feels uncomfortable when it blast the last bit into the muscle. Using DP Winstrol 50 so where am I going wrong? If i have to use a 22g everyday this is the last time i run a depot.

I have not had crazy soreness or pain like I have read about with this compound as a side note.

The answer is 23. I have seen many struggle with 25s. Same experience as yours. If you tried too many times now, the dosage in mg/ml will be off because of the product that didn’t squeeze through.

Originally Posted by Enigma

The answer is 23. I have seen many struggle with 25s. Same experience as yours. If you tried too many times now, the dosage in mg/ml will be off because of the product that didn’t squeeze through.

Yes sir thats what i was thinking now about the carrier fluid now. Last night the 22g was making balls on the tip in the vile, but i did find that injecting at a higher rate of speed with out stopping seemed to work better as well.