-
Pins and syringes 1st cycle
I'm going to start my first test-e 12 wk. What pins and syringes is needed?
Sent from my SM-G965U using Tapatalk
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
----
-
Originally Posted by
Brick Crusher
I'm going to start my first test-e 12 wk. What pins and syringes is needed?
Sent from my SM-G965U using Tapatalk
1in × 25g
----
-
Originally Posted by
Brick Crusher
I'm going to start my first test-e 12 wk. What pins and syringes is needed?
Sent from my SM-G965U using Tapatalk
How lean are you? I would recommend 1 inch pins if your a little beefy
I use 1/2 inch 29gauge
And hit it where I’m the leanest
Sent from my iPhone using Tapatalk
----
-
20-21g to draw. Dont go 18g as too many UGL's use crappy stoppers that shred. Don't go smaller than a 21g for drawing.
Make sure to have same gauge, about 25g, with 1" and 1.5" for pinning. 1" for delts, chest, etc... and 1.5" for quads, glutes etc.
Sent from my Pixel 2 XL using Tapatalk
----
-
----
-
First cycle 1inch is pretty standard everywhere , personal preference is 23g
Sent from my iPhone using Tapatalk
-
Post Thanks / Like - 2 Thanks, 2 Likes, 0 Dislikes
----
-
Most labs these days use such thin oil that there’s really no need for a large gauge to draw with. I like use same gauge that I pin with always swapping out the one I used to draw for a new one to pin . I always use 25 gauge 5/8 BD luer lok
-
Post Thanks / Like - 2 Thanks, 2 Likes, 0 Dislikes
----
-
Get a vial adapter. You won’t need 20g or 21g draw needles anymore. I use 3cc syringes with 25g quad or VG. Like butter.
Sent from my iPhone using Tapatalk
-
Post Thanks / Like - 1 Thanks, 2 Likes, 0 Dislikes
----
-
I draw with 23g pin into 3 cc tube
I then backload a 28g 1/2 inch slin pin and inject IM (usually into VG or delt)
If I am doing more than 1 cc I backload multiple slin pins and inject in multiple places
Smooth flow
No force needed it just glides in
I always use the EasyTouch slins been doing this for years w no issues — only time I had an issue is I pinned 3cc short esters into VG and didn’t 1) slightly vary injection site and 2) one of these injects was subq accidentally bc I was rushing
^^this is the way I always pin
I buy like 400 of these slins at a time and they last me for few months (I use them for peptides , GH and oils )
Shit is amazing — no need for a huge harpoon scarring my tissue daily
Sent from my iPhone using Tapatalk
-
Post Thanks / Like - 1 Thanks, 3 Likes, 0 Dislikes
----
-
20gx1” to draw, 25x1” to pin. I pin delts and glutes. Right now I draw with a 1cc syringe, mix in a 3cc.
----
Bookmarks