Thread: Post injection Pain

I have some gear Test Cyp 300, pins smooth as hell, but the next day i walk with a limp and have trouble getting in and out of vehicles for a day or two. I always pin glutes and massage the area for at least a minute. Do you think its high BA? Why the delay though?

what lab? BA can too low or way too high....I have pinned stuff that was at 250mg as would cripple my ass the next day...I threw it away and thesource. I have pinned 350 that was ultra smooth and no pip.

Hard to say bro, could be a lot of things. could be the brewer

How many Mls are you pinning? Do u sit on a heat pad for 30 minutes after the shot?

WhenI was pinning AML, there was basically no pip at all. (sust 250, test e, and mast) now I'm running some of the shit from Auexis and it is funny cause there is a small amt of pip (nothing big) after the injection, but it is totally gone the next day. and we wont even talk about the pip I got from the one and only time I pinned some of parsifals shit..... And I usually dont pin anything less then 2cc's not sure if that matters

Some things I have recently noticed on this subject. When you inject you have to be slow and still. Wobbling around will make it painful. Use one needle to draw and another fresh needle to inject. Every top you poke through dulls the needle. I am using Test P and NPP and Test E. There is something with the prop. If I put it in a rear delt slight pain a day or two after. In my glute is much worse. I think its because I spend 3hrs every day driving and those crystals grind in and iritate, leaving a swollen knot. Same gear same amount in rear delt very little discomfort.

Thanks guys I only pin 1 -1.5 mls, 1-2x wk alternating glutes, have been doing it for several years. 1.5" 23 ga. for a short while i used 1" and the pip was a lot worse. I can tell the difference between labs, some shit I've pinned i never feel it once i remove the needle, other shit was so painful i couldn't walk for a week, this shit pins smooth but the next day leaves me sore, was wondering what it could be, they are not a sponsor on this board though. BTW which one of our sponsors has smooth long ester test with out the soreness?

I couldnt deal with pain for a few days..if it happens to me with a new lab i get rid of it..you could dilute it with sterile oil or cook off the ba and see if that helps you..

heating pads, warming it up, going in slow ect ect ect really doesnt matter if you got smooth gear and you hitn in good spots. sounds like its the gear bro, you been pinning a while and now all the sudden.....theres your answer

Thanks guys for the responses, yes I know its the gear, my origional question was does anybody know whats in the gear to cause the delayed pip?

Just my 2cents, if I'm running UGL Gear, once I've got my pin loaded ill put it in a cup then run hot water in it for several minutes. I also always pin after a hot shower and pre massage and heat inj location.