Thread: Severe pain

Originally Posted by Quiggy

Is 1 ml in 1 injection to much then

I'm guessing you're only running test right now. I would say dilute it with the other compounds. Anything that's truly above 300mg per ml is very likely going to have pip. Try 1/2cc and see how it goes. You'll get better results splitting up your weekly mgs anyways. You're most likely experiencing when a pin runs. You pinned a bad spot with some harsh gear and now you can see redness where the oil travels. It's happened to me a decent amount of times. Recently I pinned ment in some built up scar tissue in my quad. The exact same thing happened to me. I knew pinning my quads was a bad idea in the first place because they've been pinned a lot over the years. You're going to have to lay off that area for a while. After a month or two press and feel that area. If it feels a little tight and harder than usual it might end up being a no pin zone from now on. Back to the question though. I highly doubt it's an infection. And it's not cellulitis. Hopefully you just hit a nerve or vessel which is easy to do in the glute. Or it could just be too much ml with that high mg gear. My guess is high mg gear in a spot with built up scar tissue. Dont use cold therapy. You want to thin out and help your body dissolve any Crystal's. Heat and message best you can. Heating pad, hot baths and message.

Woah...I've pinned a 400mg/ml test before and that can hurt like hell. I would mix it and pin every other day and still end up with big red almost rashes around wherever I injected. The hospital is going to say infection and give you some antibiotics to be safe, but I agree with Exo that's its probably just because of so much of a harsh mix going in at once. I think heat helped, but it was a long time ago and I only used 1 bottle to see how it went. I was too much of a bitch to get more.