-
High mg/ml will hurt. You can minimize the pip by diluting it with sterile oil or another low pip oil. I.E test-e 200mg/ml can work.
----
-
Originally Posted by
Quiggy
Is 1 ml in 1 injection to much then
I'm guessing you're only running test right now. I would say dilute it with the other compounds. Anything that's truly above 300mg per ml is very likely going to have pip. Try 1/2cc and see how it goes. You'll get better results splitting up your weekly mgs anyways. You're most likely experiencing when a pin runs. You pinned a bad spot with some harsh gear and now you can see redness where the oil travels. It's happened to me a decent amount of times. Recently I pinned ment in some built up scar tissue in my quad. The exact same thing happened to me. I knew pinning my quads was a bad idea in the first place because they've been pinned a lot over the years. You're going to have to lay off that area for a while. After a month or two press and feel that area. If it feels a little tight and harder than usual it might end up being a no pin zone from now on. Back to the question though. I highly doubt it's an infection. And it's not cellulitis. Hopefully you just hit a nerve or vessel which is easy to do in the glute. Or it could just be too much ml with that high mg gear. My guess is high mg gear in a spot with built up scar tissue. Dont use cold therapy. You want to thin out and help your body dissolve any Crystal's. Heat and message best you can. Heating pad, hot baths and message.
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
----
-
This is why I dont pin my quads anymore. If I'm going to have a reaction I would rather it be in my glute than anywhere else.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
----
-
Not sure if it's been said, but I hope you are rotating inj. Sites. That area is probably inflamed and will hurt no matter how much you pin there
----
-
Originally Posted by
RN2023
I’m dealing with the same thing with hgh injections in my abdomen. Big welts, swollen, red n warm to touch. The dosage is correct, so I don’t understand how it’s happening. And, they’re only insulin needles
Just a shot in the dark, but are you letting the rubbing alcohol totally evaporate from the draw/pinning area? If not that can sting like hell and really irritate the area.
----
-
I have pinned 2 ml before, but never that high of a concentration. If memory serves, mine was tested, e 250, tren 150, and primo 250 that i batched up. Did 2 ml in hip.
I recommend using hip to injection personally. I've been rotating ledlft and right since I got put on trt 4 years ago, which led me to an interest in this path to begin with.
I know everyone is different, but this leads me to believe that if it is not an infection, then it is definitely the high doseage. I would back load it into a syringe and dilute it down as others have suggested and see if the issue persists. If it does, then definitely contact your sources rep.
Sent from my SM-S918U using Tapatalk
----
-
Originally Posted by
PJ034
This is why I dont pin my quads anymore. If I'm going to have a reaction I would rather it be in my glute than anywhere else.
Agreed! I laid off quads for a long time. Then that blast I was pinning so much I needed to add in a few more pin sites. So against my better judgment I started back hitting quads. Never again. Only thing going in quads from now on is gh or igf.
----
-
The 1 time i ever injected in a glute i got a similar issue but mine turned into a nasty abcess,i dont remember what the compound was but that was it for me as far as glute injects go. As previously mentioned heat is best to try and sooth the pain.
----
-
Originally Posted by
Exo-Gen
800mg in 2ml is to much at one time for 90% of guys. i'm going to suggest split that in to two times per week
to me it sounds like you hit a vessel or nerve which can swell up and hurt pretty bad. throw in high mg in low volume pip and you got a winner.
-make sure to stay out of that glute for 4-6 weeks
-always aspirate
-if uncomfortable pull out and change needle tip and move over one inch (i just did this yesterday)
infection is last resort as by default gear when made right/normal, has chems in it that kill all the bacteria and continue to set in the chems. of course made with high heat and filtering process and all that even further the case. and one can assume your doing everything right on your end. however a user can still make the slightest unnoticeable mistake
Whatta guy whatta guy..... well said.....
----
-
Originally Posted by
Loomer1
Agreed! I laid off quads for a long time. Then that blast I was pinning so much I needed to add in a few more pin sites. So against my better judgment I started back hitting quads. Never again. Only thing going in quads from now on is gh or igf.
I can barely walk, let alone lift, if I pin quads. I don't know how this do it.
I always pin hip or gluten and rotate sites. I also would rather pin small doses three or four times a week.
Sent from my SM-S901U using Tapatalk
----
Bookmarks