Crashed Gear

[Superszme]

So I came across a couple vials of test prop that I forgot I had. One vial was completely fine. It was a 20ml vial with 6ml left. The other vial was brand new a was thick and white. I was going to try to rebound it on a coffee maker but after about an hour in my gym bag, it was clear again without any indication of it crashing. Just wondering what you guys think? Should I write it off or is it good to go?

[PAiN]

It is fine just make sure it is clear before injecting. It happens from time to time especially this time of year with the fluctuations in temperature.

[Superszme]

Just using this as a pre load before I run the EGH Labs auction cycle

[kubes]

Warm it up it should be fine. I have had gear crash many times. It happens if it gets below 70 degrees. I put it on my stove on medium heat until it all dissolves. Then I let it sit at room temp till the next day just to be sure it doesn't crash again.

[Loose Cannon]

i ran tren that crashed every single time i went to inject. i just heat it up with wifes hair dryer. way easier than messing with anything else. faster too. a sponsor on here once told me just never bring it to a boil and the gear is fine.

[prodigy6422000]

wrapping a heating pad around the gear works very good too.

[kubes]

wrapping a heating pad around the gear works very good too.

Using the oven top is much faster though and you make sure everything is dissolved before you pull it off. It only takes a minute or two

[cominback22]

I have been using loose cannons technique. Works pretty good.

[MrWiggles36]

Had a buddy who used to pop it in the microwave before every pin.

[enrod]

Lol I wouldn't feel too good about the microwave option. Coffee heating plate works good enough for me.

[kubes]

Had a buddy who used to pop it in the microwave before every pin.

No do not do that

[Superszme]

No do not do that
Wouldn't even cross my mind

[MrWiggles36]

No do not do that

never really agreed with it either, always thought it was funny.

[Atlas Labs]

When I was younger I would boil water let it sit and swirl it around. I would repeat the process untill everything was clear again. Doesn't take much time at all

[Bambam]

Hair dryer is very fast no water to boil and works great

[3bagsfull]

Good to see the number one must have utility of a woman is being used well. AKA the "Hair dryer" LOL

[silntrunin]

Most of the time once you reheat prop, it should hold and not crash again provided you don't expose it to cold temps. I've had TNE that had to be reheated everytime i pinned but thats a total different beast.

[underpsi]

have always put my gear in warm water before injecting anyway.. put coffee mug in microwave for 1 min til warm .. drop vial in while getting pins ready... makes it easier to draw and inject.

[rachellmc]

Glad that it fixed .Too much powder, too little solvents or even cold weather can cause crashed .