Inject Dbol

[Dungan23]

So I had a question in regards to running some inject dbol, so since it is run so frequently (ed) would it be ok first to pin these with .5 27g slin pin and if so could you preback load about a weeks worth of pins or would possible problems arise like rubber breaking down from the compound or something?

[Vision]

So I had a question in regards to running some inject dbol, so since it is run so frequently (ed) would it be ok first to pin these with .5 27g slin pin and if so could you preback load about a weeks worth of pins or would possible problems arise like rubber breaking down from the compound or something?
This will depend on the ratio of solvents and quite possibly the type of carrier oil whether EO or Guaiacol, all of these could degrade the rubber on the plunger, slin pins are very delicate.. so pre-loading them may not be advised..

I don't know what source you got it from or what recipe they used so the viscosity will vary from other brands, but you can back load and give it a shot..