PDA

View Full Version : Thigh and Shoulder PIP



swolesoul
02-02-2019, 04:15 AM
I have exclusively been pinning glutes for over 15 years. I decided to try thigh and shoulder sites. I used test oil from source here that left no pip at all on my glutes. Both pin sites literally crippled me for a couple of days. Test 250 1 ml with a 25 gage 1" needle, skin stretched and needle entry at a 45 degree angle.

Lostcause
02-02-2019, 04:17 AM
Hit them at a 90

Sent from my SM-G960U using Tapatalk

MEB
02-02-2019, 04:17 AM
If u have never shot shoulder and this is your first time it will hurt some. You may have been moving the pin and not knowing it it's new skin it will take time

Sent from my SM-G960U using Tapatalk

SadSavage1
02-02-2019, 04:42 AM
That happened to me a couple of times. I'm used to pinning my shoulders with a 25 gauge 1 inch. I decided to switch the site to quads, but I use a 5/8 inch 25 gauge, so far no problems...

Sent from my LG-M153 using Tapatalk

9TMARE
02-02-2019, 04:52 AM
Its happened to me as well. In the quads the first few times made it a bitch to walk, sit etc. Its gotten better over time and now they can handle smaller doses just fine. Not sure if it’s recomended but I’ll roll out the quads after hitting...seems to help. As for shoulders...ehh not sure I’ll do those ever again lol.

SadSavage1
02-02-2019, 04:57 AM
When I used a 1inch 25 gauge on my quads that shit crippled me for like a week lol had to call in to work cause I couldn't even walk for reals,Now that I changed it to a 5/8 everything is all good. It wasn't the gear it was the size of the needle, but everyone respond's differently

Sent from my LG-M153 using Tapatalk

BombdotCom
02-02-2019, 12:34 PM
Be careful when going 90 degrees on your quad. Your IT band runs down the side. I usually flex look for the biggest chunk half way then go in. Pinning quads changed eveything for me. So easy and hard to fuck up.

Sent from my SM-G960U using Tapatalk

Yellowninja
02-02-2019, 01:32 PM
Oil quantity makes a difference too. I had to start low volume and slowly work up. I think you basically need to train the muscle. start low and keep increasing the volume just like weights in the gym

bigpapapumpaf
02-02-2019, 08:07 PM
You have to go in at a 90 angle, look at how the muscle is layered. 25ga is Ok but I always prefer 27ga. Its painless, slower but no issues.

BPP