-
BAC water injecting too fast into hgh
i draw my bac water with 25g 1"pin and wen i stick the needle in the hgh it automatically just gets sucked right in?i even tryed to hold the plunger so it doesnt do it and it does?this is my 3rd 10 iu vial i am on that this happens?any tips i dont want to ruin my hgh?also can never get the last 2iu out when i draw with my slin pin i guess 1/2 is to short to grab the last 2 iu i am wasting hgh this way any tips??
----
-
I have this same problem with the BAC water just shooting right in. Following
----
-
Why not inject air into the vial first before you inject the water?
----
-
Just stick the needle in and let the air escape
-
Post Thanks / Like - 1 Thanks, 2 Likes, 0 Dislikes
----
-
immediately as i stick the needle in the water instantly goes in, 1cc of bac water
----
-
The pressure in the vial is lower than outside so it will do that. Take the needle (without barrel), put it in to equalize pressure before adding water. Works with all injectables
-
Post Thanks / Like - 1 Thanks, 4 Likes, 0 Dislikes
----
-
Originally Posted by
Ironman 580
immediately as i stick the needle in the water instantly goes in, 1cc of bac water
Use an empty syringe of air. Or take the needle off the syringe and puncture the vial and let the air pressure equalize.
-
Post Thanks / Like - 0 Thanks, 3 Likes, 0 Dislikes
----
-
Stick the vial with an empty syringe, and then unscrew the needle allowing the vial to vent now just screw the syringe back onto the pin and pull it out. The vial is now vented and ready for you to inject the bac water without it being sucked right in
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
----
-
Originally Posted by
JustinMoose
The pressure in the vial is lower than outside so it will do that. Take the needle (without barrel), put it in to equalize pressure before adding water. Works with all injectables
Moose has U covered, exactly what I do.
Get rid of the vacuum/ equalize pressure!
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
----
-
Vent it with a spare needle to equalize the pressure before you stick your pin with the water in it.
I always reconstituted with a slin pin 1ml at a time. I always made sure to squirt down the side of the vial and then gently swirl to get it all into solution then I add the rest of the bac water. Whether or not this is sound advice I'm not sure, that's just how I was taught and it's worked for me.
----
Bookmarks