Thread: Test e powder melted

Also think of this. I am very carefully when doing this part. Say your making 100ml test e say you place that breaker in a pot of boiling water and the breaker is fully open on top. You can clearly see the water vapor on the outside of breaker there will be some that will go into the breaker. And water and hot oils will make the cloudy look

Originally Posted by E-V-I

Also think of this. I am very carefully when doing this part. Say your making 100ml test e say you place that breaker in a pot of boiling water and the breaker is fully open on top. You can clearly see the water vapor on the outside of breaker there will be some that will go into the breaker. And water and hot oils will make the cloudy look

Why would you expose your compounds to open vapors. Seal your vial and put a needle in the top. This insures proper sterilization and also to keep water out.

Originally Posted by Dionysus

Why would you expose your compounds to open vapors. Seal your vial and put a needle in the top. This insures proper sterilization and also to keep water out.

So you put your powder right into the vial and place stoper then cap on and crimp, then put in pan with hot water ?

I I must be doing it wrong. I use a 250ml breaker add ba and bb then powder , devolve powder add oil then draw up oil into syringe then place a filter on and filter into a sterile vial.

IT REALLY DOSNT MATTER HOW U MIX IT AS LONG AS U DISSOLVE ALL THE CRYSTALS IN THE BEAKER BRO.... ITS JUST PREFERENCE ON HOW U WANT TO ADD CONTENTS... MOST DO BB/BA WITH RAWS THEN HEATED OIL... THIS IS THE TRIED AND TRUE WAY ON MIXING .. MAKE SURE ALL THE SWIRLS ARE GONE BEFORE U START TO FILTER..