Crashed Gear

**Superszme** · 02-24-2015, 10:57 PM

So I came across a couple vials of test prop that I forgot I had. One vial was completely fine. It was a 20ml vial with 6ml left. The other vial was brand new a was thick and white. I was going to try to rebound it on a coffee maker but after about an hour in my gym bag, it was clear again without any indication of it crashing. Just wondering what you guys think? Should I write it off or is it good to go?

**PAiN** · 02-24-2015, 11:52 PM

It is fine just make sure it is clear before injecting. It happens from time to time especially this time of year with the fluctuations in temperature.

**Superszme** · 02-25-2015, 12:04 AM

Just using this as a pre load before I run the EGH Labs auction cycle

**kubes** · 02-25-2015, 12:07 AM

Warm it up it should be fine. I have had gear crash many times. It happens if it gets below 70 degrees. I put it on my stove on medium heat until it all dissolves. Then I let it sit at room temp till the next day just to be sure it doesn't crash again.

**Loose Cannon** · 02-25-2015, 01:39 AM

i ran tren that crashed every single time i went to inject. i just heat it up with wifes hair dryer. way easier than messing with anything else. faster too. a sponsor on here once told me just never bring it to a boil and the gear is fine.