Thread: masteron E crashes.. what's wrong???

first attempt at brewing.. tried masteron E at 200/ml and when it cools/stored for more than one day it crashes.. put it in a bath of warm water and it reconstitutes itself fine. no crystals at all.. here's recipe i used.
10g powder
33.5 Grapeseed Oil (GSO)
1.5ml BA (3%)
7.5ml BB (15%)

any suggestions? thank you

I used bass killer and this is what I got.

thank you....

You're welcome. Hope it works out for u.

used the calculator ... did 1/4 of what you put in
10g
30.5 gso
1ba
9 bb
still same !!! not really separating but cloudy when cold... when i put in warm water for 2-3 min looks perfect again... go figure. thinking maybe was sent mast prop not eth.

Originally Posted by underpsi

used the calculator ... did 1/4 of what you put in
10g
30.5 gso
1ba
9 bb
still same !!! not really separating but cloudy when cold... when i put in warm water for 2-3 min looks perfect again... go figure. thinking maybe was sent mast prop not eth.

Sorry to hear it didn't work. The calc is usually gtg. Maybe there is an old pro in here that will see this and help.

Originally Posted by underpsi

used the calculator ... did 1/4 of what you put in
10g
30.5 gso
1ba
9 bb
still same !!! not really separating but cloudy when cold... when i put in warm water for 2-3 min looks perfect again... go figure. thinking maybe was sent mast prop not eth.

Not positive but the amount of mast per ml may be to high. I have a list and the highest they went was 166mg/ml. So maybe just to high concentration. Like I said I don't really know for sure. Someone else on here surely knows.

I don't get the ? The calculator is not hormone specific as far as I know

It has a weight displacement at the bottom Ski. It has a few compounds under the weight list and mast is 1. Check it out and see what u think. It was basskiller and it's right below the chart

Had the same problem .I raised the heat a little higher and cooked a little longer. Presto good product.