Thread: Brewing for second time

Hi guys,

Second time brewing and i wanted to increase the concentration a little this time. My first brew i successfully made test e @ 250mg/ml, Boldenone @300mg/ml and Tren A @100mg/ml using MCT Oil

Second brew I plan to use the following:
Test E @ 300mg/ml 15%BB 1%BA
Boldenone @ 400mg/ml 15%BB 1%BA
Tren E @200mg/ml 15%BB 1%BA
Test Prop @ 100mg/ml 18%BB 1%BA

My question is do i need to alter the BB and BA content for any of these and also will the Boldenone be painful @ 400mg/ml?

Originally Posted by Kobra

Hi guys,

Second time brewing and i wanted to increase the concentration a little this time. My first brew i successfully made test e @ 250mg/ml, Boldenone @300mg/ml and Tren A @100mg/ml using MCT Oil

Second brew I plan to use the following:
Test E @ 300mg/ml 15%BB 1%BA
Boldenone @ 400mg/ml 15%BB 1%BA
Tren E @200mg/ml 15%BB 1%BA
Test Prop @ 100mg/ml 18%BB 1%BA

My question is do i need to alter the BB and BA content for any of these and also will the Boldenone be painful @ 400mg/ml?

If you don't mind me asking will percentage BB and BA did you use in the first batch that you made?

Sent from my SM-G935V using Tapatalk

Boldenone @ 400mg/ml is fine,i hear some people even use 800mg/ml.

Originally Posted by Yukilmc

Boldenone @ 400mg/ml is fine,i hear some people even use 800mg/ml.

So in order to make a higher mg of any product, you would have to add more ba and BB or just one or the other?

Sent from my SM-G935V using Tapatalk

not like that.Exceeding a certain range will cause pain.BA don't exceed 5%,2% is common use,it's mainly used for keep stuff bacteriostatic and sterile;BB is at 15%-20% for most people with nearly painless.Anyway,it's painless at low level.

Test E & boldenone were 18%BB and 2% BA. Tren A was 20%BB and 2% BA. All are still holding and havent crashed.

Originally Posted by Kobra

Test E & boldenone were 18%BB and 2% BA. Tren A was 20%BB and 2% BA. All are still holding and havent crashed.

Test E and EQ do not need BB to be brewed. Pharm grade comes with 2% BA. BA is just a preservative, it keeps your solution sterile after all is said and done. EQ comes in liquid already, 400mg/ml will be smooth. To much BB in your gear will cause tren cough. So dont use it unless absolutley needed. Also, PIP comes from carbolic acid, is a chemical used in the manufacturing process of the raw. You can make test e @400mg/ml without BB and itll hold and be smooth.