-
Problems with brewing Test?
Having problem with brewing the test. No problem with anything else, just the test.
Every batch I've made so far has had the same problem. The batch looks clear, doesn't have any pain during the injections. After the injection the muscle swells and becomes a hard mass sometimes with redness for about 5 days. Have made gains, sex drive is through the roof, more energy, better sleep. It takes about 5 to 7 days for the swelling to go down and is a problem because you can't inject in the same site till it's gone plus it's hard to train with swelling like that cuz its painful and limit range of motion.
Here are some details of my brewing
Test e@300mg/ml, the mixture is 1.5% BA 18%BB the rest is a mixture of grape seed oil and ethyl oleate. I've made it without any EO and had the same results. It just seems thicker without the EO. I put it in boiling water with a very small amount of BA. Then I move it to a 500 degree oven to dry out, then I move it to the freezer until I bottle the filtered gear. I usually double filter my gear before I put into sterile bottles.
Any brothers can give me some directions on how should I fix this? Thanks in advance.
----
-
----
-
Your concentration of T may be high for you. Are you sure about the quality of your ingredients?
----
-
I have had the same thing happen about 5 years ago.
The final outcome was carbolic acid.
Try googleing this and read read up on how your body reacts. I was kicking myself in the ass making batch after batch thinking I was doing something wrong.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
----
-
If you are sure that 1) your gear is sterile
2) your vial's sterile
3) Your pin's sterile
4)your injection's sterile.
Then it is called the Test flu. Sometimes the injection sites also get red& swollen. It's just to make sure all gear and equipment's sterile so I'm not getting an infection.
Hang in there, you should be good to go.
Last edited by Apple; 11-24-2017 at 04:00 AM.
----
-
If you are sure that 1) your gear is sterile
2) your vial's sterile
3) Your pin's sterile
4)your injection's sterile.
Then it is called the Test flu. Sometimes the injection sites also get red& swollen. It's just to make sure all gear and equipment's sterile so I'm not getting an infection.
Hang in there, you should be good to go.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
----
-
Raise the BB in it will help a lot brother. Also change carrier oil to mtc oil .
----
-
Originally Posted by
Woods
Raise the BB in it will help a lot brother. Also change carrier oil to mtc oil .
Thanks, the GSO I use isn't so green, more clear, it's organic wasn't cheap either.
I will try to use MCT oil in my next batch, still has a little powder.
----
-
I think all my equipment is sterile, as I said I use a 500 degree oven to dry out. Anyway, it's an idea that I will pay attention to, thanks.
----
-
Originally Posted by
balin
Your concentration of T may be high for you. Are you sure about the quality of your ingredients?
You mean the quality of BB, BA and oil?
----
Bookmarks