-
Originally Posted by
Plate Smacker
I heat deca up to 180F while stirring, then remove from heat, still stirring. I let it cool down, while stirring, to 105F, then filter.
So i don't really leave it at a certain temp for any amount of time really.
Shaking the vial will not damage the hormone.
When I am going to pin...
My sink water is 110F hottest.
I submerge my vial 3/4 way up, in hot water bath (sink) while I take a shower.
I then remove from hot sink bath, dry off glass, shake for about 10 seconds.
Then draw after alcohol feom swab evaporates.
I will be brewing 400mg/ml 1%BA and 5%BB here in the near future. That is same percentages I use for 300mg/ml.
It's been 6-7months since you said you'd be brewing that and I'm about to make another batch. How did it turn out? Less BB I can use the better.
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
----
-
Originally Posted by
Cratos
It's been 6-7months since you said you'd be brewing that and I'm about to make another batch. How did it turn out? Less BB I can use the better.
I ended up moving to lower dose blasts, so I would not need 400mg/ml since I don't need to go above 600mg/wk.
If my 300mg/ml can hold easy at 1%BA and 5%BB in MCT oil... I am sure 400mg/ml can hold at 1%BA and 10%BB.
"It's a lot of hard work, it's hard work that most people don't realize. I think the consistency of the hard work, is the hardest part." Dallas McCarver
----
Plate Smacker thanked for this post
Plate Smacker liked this post
Reply With Quote
Bookmarks