Deca 400mg/ml

**Cratos** · 08-14-2018, 01:43 AM

Yesterday, I brewed Deca 400mg/ml and wondering if there are any signs that it has crashed or not working without actually using it. I am worried I may have heated it too much. Had the beaker in a small pot with water up until it covered the contents of the beaker on low heat and slowly mixing for like 30min until everything was dissolved, it started bubbling a bit a few times and I took it of before putting it back on the burner and stirring.

These are photos of the end product. The first 2 pics were taken in different lighting, third was a very slight shake to see what it looks like. Don't know if shaking it can damage it so I barely did it. Input would be appreciated.

Recipe:
10 grams powder (ND per 1 gram displaces .962 MLs)
12.88 ml MCT Oil
2.50ml BB 10%

IMG_0161.jpg IMG_0163.jpg IMG_0166.jpg

**Symbion1** · 08-14-2018, 02:30 AM

Looks good mate, no worries in that process.

**Cratos** · 08-14-2018, 04:16 AM

Originally Posted by Symbion1

Looks good mate, no worries in that process.

Great, thought that the heat could have damaged it.

**korsaire** · 08-14-2018, 04:52 AM

you dont need that much of water in your pot

**Indahood** · 08-14-2018, 07:32 AM

Yes looks pretty clean. I don't think so heat would damage it as long as you dont go above 70-80C degree

**HalleHood** · 08-14-2018, 10:56 AM

Good stuff

**THX** · 08-14-2018, 06:05 PM

Looks good!
Is that a 20ml vial?

**Cratos** · 08-15-2018, 04:15 PM

Originally Posted by THX

Looks good!
Is that a 20ml vial?

30ml

**Plate Smacker** · 08-15-2018, 11:35 PM

I heat deca up to 180F while stirring, then remove from heat, still stirring. I let it cool down, while stirring, to 105F, then filter.
So i don't really leave it at a certain temp for any amount of time really.
Shaking the vial will not damage the hormone.
When I am going to pin...
My sink water is 110F hottest.
I submerge my vial 3/4 way up, in hot water bath (sink) while I take a shower.
I then remove from hot sink bath, dry off glass, shake for about 10 seconds.
Then draw after alcohol feom swab evaporates.

I will be brewing 400mg/ml 1%BA and 5%BB here in the near future. That is same percentages I use for 300mg/ml.

**THX** · 08-16-2018, 06:59 PM

Originally Posted by Plate Smacker

I heat deca up to 180F while stirring, then remove from heat, still stirring. I let it cool down, while stirring, to 105F, then filter.
So i don't really leave it at a certain temp for any amount of time really.
Shaking the vial will not damage the hormone.
When I am going to pin...
My sink water is 110F hottest.
I submerge my vial 3/4 way up, in hot water bath (sink) while I take a shower.
I then remove from hot sink bath, dry off glass, shake for about 10 seconds.
Then draw after alcohol feom swab evaporates.

I will be brewing 400mg/ml 1%BA and 5%BB here in the near future. That is same percentages I use for 300mg/ml.

You'll need a lot more BB for it to not crash.