-
possible to recook not to waste?
i made some home brew test E at 300mg / ml in a small 30ml batch. stuck to the calculator as i have before , and never had issues before, however i may have put more benzyl alcohol than i should have if im remembering, possibly by .2 ml over the recommendation. the batch ended up causing me to get redness and some swelling. could that be from the BA, and if so, could i just re cook it? add more gso and dilute it down and add 20 ml more oil and make it into 50 ml total? will recooking solve this , or is this not safe? jsut want to check on that before tossing this vial.
----
-
Pull from vials, add more oil, filter and rebottle.
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
----
-
thats what i planned to, havent done it before and wanted another person to verify. thanks !
----
-
That is the way to go, add oil and the concentration of BB will be lower. Also the concentration of the hormone itself will be lower ml by ml
Sent from my iPhone using Tapatalk
----
-
If the oil in not sterile then refilter.
----
-
Also, something to keep in mind is that it may not even be the additional BA in your brew. It very well could be the Carbolic Acid that some Test E batches are infamous for. It really has made a world of difference with that compound it I heat the oil up to around 250 degrees for 30 minutes and then when it cools to add my solvents. Always makes it painless and I make mine anywhere from 300-400mg/ml. Last batch I made I made it 300mg/ml with no BB in it at all. Just the standard 2% BA and it is as smooth as it gets. However if you did this you would probably end up evaporating all your solvents out of your brew at this point. Like what was stated above, add more oil and see if that helps. But if you get it back down to 200-250mg/ml and that shit still makes you red and welted up, then I almost guarantee it's the high level of acid in it that is causing the pain. Just my 2 cents.
----
Bookmarks