I'm home brew quite often test, deca, eq, tren but i've never attempted to brew some winny. I will be attempting soon so if anyone has a different recipe then the one i found in the recipe sticky i would a appreciate it.

Where does someone find Mr T super solvent? Also can Mct oil or GSO be substituted for sesame?


Winstrol

Note: there is a tendency to ruin the product during conversion so only use one gram at a time

Powder: 1 gram
Produces: 20 ml at 50 mg/ml

Requirements:

  • 1 gram of winstrol
  • one 20 ml glass vial or larger
  • one 20 ml sterile glass vial or larger
  • one 0.45 Whatman sterile syringe filter
  • two 5 or 10 ml syringes
  • two 3 ml syringes
  • three 18 or 20 gauge pins
  • two 22 gauge pins
  • 17 ml of sesame seed oil
  • 0.2 ml of benzyl alcohol
  • 2 ml of Mr.T super solvent

Procedure:

  • measure one gram of powder
  • draw out 2 ml of the Mr. T super solvent using one of the 3 ml syringes
  • place the measured powder in the open vial and add the solvent
  • place the rubber stopper back on the vial and put one of the 20 gauge pins in the stopper
  • place the vial in a small pan and place the pan on the eye of the stove
  • heat until the powder dissolves into a liquid (usually around 239.8-242 degrees F)
  • turn off the heat and let it cool down in the pan to room temperature (approx. 15 minutes)
  • heat the oil in a suitable container in the oven until it reaches a minimum of 212 degrees F to sterilise it (it will be necessary to use slightly more oil than is required as all of it will not be able to be utilised)
  • draw out 0.2 ml of benzyl alcohol (this will account for 1% of the solution so make sure the measurement is correct)
  • add the benzyl alcohol to the solution in the vial and shake very gently
  • draw out the oil with the 10 ml syringe (make sure the oil has cooled down somewhat before doing this)
  • add 15 ml of the oil (saving 2 ml for later) to the solution in the vial and shake very gently Note: If the winstrol begins to clump back up, reheat the solution (place in a pan, put the pan on the eye of the stove and heat until it liquefies again) and allow it to cool down slowly
  • place one of the 18 gauge pins in the sterile, unopened vial and attach the Whatman sterile filter
  • draw out the solution using the other 10 ml syringe, attach to the filter, and slowly press the solution out into the sterile vial
  • use the previously saved 2 ml of oil in the other syringe and run it through the filter to ensure that all the Winstrol passes through
  • after the filtering process, leave the pin in the sterile vial and remove the filter
  • place the vial in a pan and place the pan on the eye of the stove
  • heat for 15-20 minutes, remove from heat, and let it cool down to room temperature (approx. 15 minutes)

The finished solution will be light-gold in colour.
Ensure that you follow the guidelines carefully for this conversion.