-
Oral clumped in oraplus
So I put
15ml oraplus
14.25ml distilled water
0.75g proviron
6 drops food dye
Into a dropper and shook it up for a couple minutes and the powder clumped. Any ideas what I did wrong or what I can do? I heard it always suspended easily and this is my first experience with oraplus
Sent from my iPhone using Tapatalk
----
-
I never been big on using proviron, but last time I used it I had no problems suspending it in alcohol "polish spirit" at 25mg/ml.
Regards,
S.
----
-
Originally Posted by
Mr. S
I never been big on using proviron, but last time I used it I had no problems suspending it in alcohol "polish spirit" at 25mg/ml.
Regards,
S.
Yeah I just personally wanted to avoid the alcohol route! And heard good things about oraplus
Sent from my iPhone using Tapatalk
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
----
-
Maybe you can put it in a magic bullet or a small blender and break it all up. Then take a little more distilled just to wash out the extra... just a idea .
Everyone wanna be a Beast, Until it’s time to do what Beast’s Do!!!
I S Y M F S
(It’sStillYourMutherfuckingSet)
----
-
It needs to be blended, not merely put into a bottle and shaken. Our batches are made in large beakers so we use a T-Fal immersion blender and periodically blender during bottling.
For crystalline hormones (like anavar) I put into a media bottle and macerate with a small amount of water using a homogenizer. Unfortunately this device is cost prohibitive for most home brewers. The crystalline hormones don’t dose properly otherwise.
----
-
Mortar and pestle the shit out of it next time. You also have to shake the shit out of it as you go. Don't just dump everything in there and shake.
Using the handheld blender would be a good idea. This is the exact reason why I picked up some PEG. I'm getting tired of suspensions.
----
-
Too much water in there with it. With Proviron, Winstrol, Anavar, Tbol, and Nolva, I would recommend using 40% OraPlus or Humco Flavor Plus, 40% OraSweet or Humco Flavor Sweet, 10%Everclear or highest proof alcohol you can find, and 10% Distilled Water. Certain orals are just a bigger bitch to put into a solution or even make suspensions due to their Molecular weight and high melting points. This is just what I have noticed.
----
-
I do the same process as you OP. I’m not a fan of using alcohol, and I don’t do large batches.
I just shake the shit out of it before drawing from it, and use a liquid mL dropper to draw.
Yeah it’s not the prettiest, and probably a few steps from precise, but it seems to get the job done for small batches and individual use.
Sent from my iPhone using Tapatalk
----
-
Add a small amount of Ora-plus to the powder and mix till it forms a paste then start adding more of the Ora-plus till you get the concentration that you want. That is how compounding pharmacies tend to do it.
----
-
Only problem with the blender is I’m doing such small batches I don’t the volume will be sufficient enough to blend haha
Might try the paste idea, for the current bottle I’ll dump it into a blender and see if it does anything!
Sent from my iPhone using Tapatalk
----
Bookmarks