-
Possible homebrew technique?
I am about to make 100cc of test prop and 50cc of primo, test at 100mg and primo at 200mg per,
Now, I have always dissolved the powder in the ba/bb solution and then added to the oil, been doing it that way since finaplix h days using the old stingy finafarm kit, and THEN filtered it, which is a time killing cunt of a procedure, of course back then much of the filtering procedure was for fillers such as glue and even sawdust or whatever they put in the pellets which is not necessarily for raws BUT
My question is, what if I filtered the ba/bb/raw powder solution and then added it to the oil which I would have heated to sterilize (after it had cooled down of course)
This would allow me to heat the oil to a temp not limited to the melting point of whatever aas I am using to completely sterilize it and the ba/bb solution is sterile as is because of the ba, basically I would be filtering it to hopefully catch any impurities of chemical residue from the lab in China or whatever country of origin.
I know there is NO way of completely sterilizing your batch short of having a clean room and autoclave etc. But this couldn't hurt?
Thoughts from the knowledgeable please
----
-
Is the oil of choice filtered with a 22um filter?
Regards,
S.
----
-
No merely usp grade, I don't usually filter oil as oil is pretty sterile on it's own, been doing this since 2002 and never had an abscess or infection, although now that I've said that Murphy is going to strike me down
----
-
I would Just stick with the standard technique
Brew then filter then bottle. There is a reason it's done this way and that is because it works. Why take unnecessary shortcuts to save a little time. I'd rather spend more time on filtering then being laid up with an infection
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
----
-
True, however hear me out, I think possibly this method might actually be more sterile because of the higher temperatures I could be baking the oil at without worrying about melting the actual aas molecules and the ba/BB/raw solution is actually sterile because of the alchohol (of which I use a higher level of ba to be safe) so what do you think? No? yes? and why on either?
----
-
Why not heat the oil to what ever temp you want then let it cool down add the raws, ba, and bb brew at temp until clear the cool to around 100 degrees then filter. That's what I do most times
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
----
-
I add all the ingredients to a Pyrex cylinder that is sitting in a pan of water the is just below boiling point. Th oil filters better then at room temp, and it is not so hot I worry about degrading the chemicals. I always filter the oil as well as everything else as I figure I am worth the extra time and trouble. And extra few minutes is preferable to what it would cost me if there were some spores or other contamination in the oil itself.
----
-
I would say you should always filter the oil regardless USP / sterile or not, yellowninjas method is the best... I been brewing like that but I usually add the ba at then end to avoid evaporation.
Regards,
S.
----
Bookmarks