I brewed 100ml's of Cyp @250mg using MCT using a heated stirrer. Went 2%BA and 20%BB. Then used .22um PDVF syringe filters and filled 20ml's per vial. This is how I always do Cyp. A couple times my filters clogged and I had to warm up the solution a bit. Other than that the vials looked fine until I drew from one well over a week later. Within the next day or so it had crashed. I reheated it and it stayed suspended for days. I went to use it again and the same thing happened. No real change in room temp at any point and it definitely didn't get very cool. Drew from the other vials to see if the problem is in the batch or isolated to the one vial and it is in the batch. So I'm trying to figure out how to approach this. Reheating doesn't seem to work as I don't want to melt the raw every time before drawing and then have to let it cool to the point it can be pinned, but I haven't ruled it out. I am also considering either: adding more BB, adding more oil or both. Being that I went pretty high with the BB, I'm leaning towards just adding oil then heating. I'm looking to get some input from anyone that might know how to deal with this. I always Rep Up anyone that helps. Thanks!
Reply With Quote
Bookmarks