EQ 300..........chemical wizards needed.....

[gator-mclusky]

Ok...heres the deal.Im no chemist!!!!!! 30 grams EQ Cyp not undecylinate. 100 mls. 300 mgs per cc

I can use the basskiller calculator but it was used on the Primo and its crashing like a jetliner with engine failure!!!!!

So......any recommendations? I need a book called Brewin for Dummies I guess!!!!lol

[flyingfox272]

I'm no wizard but 300 mg per ml and up I add at least 10% Benzyl benzoate. I am not sure what your recipe is but for me brewing with the Cyp ester would be something like this.
Oil of your choice( I have cottonseed)
3-5% BA (I keep it at 5%)
10-20% BB(I tend to use 20% to thin out the oil a bit)
Raw Powder,
This is basically what I plug into the calulator and it gives me the amount of oil needed after the displacement from the other ingredients.
This is my typical recipe and have had no issues with crashing, It even held a Test Cyp 250mg/Deca 250mg blend with no problem.

I picked up some EO and plan on using 10-20% in my next batch and cutting down on the BB to 10%. I will brew a small test batch to make sure I have no issues with the EO.

I hope this helps.

[gator-mclusky]

Excellent. Ill plug it in and give it a go. Ill try 10% BB and 3% BA. I used 18% BB and 2% BA on 100 ml 100 mgs per cc Primo Ace and its crashing bad!!!!! I guess its the Acetate ester being hard to hold......I guess.

Thanks brudda.

[jurgensplurgen]

^^ The EthylO. And definitely more BB than 10%. You could be good lower, but it makes it smoother anyway, and helps hold it, so why not keep it slightly higher then strictly necessary.
Test E n Bold Undecylate came out no problems with 3%ba, 20%bb and oil. Haven't tried Cyp yet, though soon.

[grizzlylongcut]

bold cyp is a little tricky to hold at 300mgml,ive done it at 200mgml,with 2ba 20bb,and it came out fine ,and no need for that nasty EO

[delcapone]

This worked well for me,= E.Q. 40mls@300mgz/ml
Powder = 12gr.
21.8 oil ( i used gso/eo= 50/50
1.2 ba
8ml bb

[gator-mclusky]

Well what has finally worked is I added another 2 mls (2%) BA and its gtg. So it was 18% BB and 4%BB No bite at all either.

Now my Primo I added 2% moe BA and 20 more MLs of oil and its holding at about 90% Maybe I should add some EO. Wheres a good place to find that at?

[jdb3]

EQ @ 300 for homebrew...IMPRESSIVE!!! Gator, I didnt realize your talents! Good luck on the primo, I hear thats a tough one

[RockShawn]

Try here Gator LINK

[RockShawn]

I thought you had to use guaiacol for primo ace? Tht's what I was told made it hurt like hell, same with winny in oil.