Thread: sust brewing?

just wondering if brewing sust is hard to do. Looking to brew some but want it pip free or as close as i culd to pip. thanks guys in advance

From what i have read on home brew sust, it is alot harder to brew if you dont know what you are doing, and has to be done in certain orders.

Originally Posted by bigcheeze37

just wondering if brewing sust is hard to do. Looking to brew some but want it pip free or as close as i culd to pip. thanks guys in advance

Sust is going to have some pip, regardless of what solvents or oils you use, simply due to the short esters in it. If you are used to injections, it's not too bad with the right oil as a carrier(the type of oil and percentage of solvents CAN make a difference in the amount of pip, to a degree... It can't make short esters not hurt though)...
My favorite carrier oil is cottonseed, it seems to be FAR more smooth than any other oil! For the smoothest sust possible, 2% BA/20% BB is going to be the solvent ratios/amts you will want to use... It can be made with less bb, but it's not going to be as thin, and will be slightly more painful. You can always make it at 200mg/ml, instead of 250, and it will have a little less pip..
As far as directions on brewing it, there's a brewing 101 sticky that I wrote in the homebrew section.. that should break it down for you pretty well... If you have other questions, feel free to pm me... Or write them in this post, and I'll answer them for everyone... Do still pm me if you ask a question in the post, I have several sites I have to go through daily, and don't have the time or means to do more than quickly scan the sites and check pms... But I am always happy to post on anything anyone brings to my attention!

Hope that helps some, good luck bro!
Also, if that is as2 sust, let us know how you like it under that subforum!

Originally Posted by overburdened

Sust is going to have some pip, regardless of what solvents or oils you use, simply due to the short esters in it. If you are used to injections, it's not too bad with the right oil as a carrier(the type of oil and percentage of solvents CAN make a difference in the amount of pip, to a degree... It can't make short esters not hurt though)...
My favorite carrier oil is cottonseed, it seems to be FAR more smooth than any other oil! For the smoothest sust possible, 2% BA/20% BB is going to be the solvent ratios/amts you will want to use... It can be made with less bb, but it's not going to be as thin, and will be slightly more painful. You can always make it at 200mg/ml, instead of 250, and it will have a little less pip..
As far as directions on brewing it, there's a brewing 101 sticky that I wrote in the homebrew section.. that should break it down for you pretty well... If you have other questions, feel free to pm me... Or write them in this post, and I'll answer them for everyone... Do still pm me if you ask a question in the post, I have several sites I have to go through daily, and don't have the time or means to do more than quickly scan the sites and check pms... But I am always happy to post on anything anyone brings to my attention!

Hope that helps some, good luck bro!
Also, if that is as2 sust, let us know how you like it under that subforum!

Im running Sust right now and dont have any Pip what so ever! The Sust i have is Smooth!!!

ive made sust a few times, i personally like to use 2% ba,10%bb,10% bs. i dissolve my short esters first since they take a little higher temp,then add the longer esters.. i also dont make a true sust i do 75 prop 100 iso, 100 te. comes out painless

BS???

its , benzyl salicylate